FAN 50 PLUS PINS FAN CONTROL

• The FAN 50 Plus Pins is designed to replace the new Suburban® and Atwood® / HydroFlame® Fan Control boards as well as maintain backward compatibility with the Fan 50 Plus, and UIB Fan Control boards which have been available since 1994.
• This board can also be used to upgrade older furnaces to add the Fan Control feature.
• The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try.
• Thus, battery drain is reduced and the needless blowing of cold air is eliminated.
• The FAN 50 Plus Pins , after shutting the fan motor off, will wait for 1 hour and repeat the whole sequence again before permanent shut down.
• For 12 VDC Furnaces ONLY!

No return on any electronic or electrical parts